20230318 Mounting and Underwater Testing

 Mounted MD design onto the sub and confirmed that it fit properly and did not interfere with other sensors or cameras. Tested MD design underwater and it worked. Used golf balls as markers and when released by control arms they would drift and not land in the designated location. Tested a new 3D printed control arm and it worked. 

   
at
Labels: , ,

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

20230508 Tuning In the O-Ring Size

  Parker handbook  4.3 Face Type Seals “Face type seals are sometimes rectangular. In designing such a seal to receive a standard O-ring, th...

  • 20230103 Second Version of Camera Enclosure
    20230103 Second Version of Camera Enclosure Using sealing m4 screws to mount oak-d onto back here Thinking about a male usb-c breakout board...
  • 9/11/22 Risk Reduction
    Colin Szeto Objective was to verify the feasibility of the assembly and dimensions of the motor guard around the physical motor before laser...
  • 20230125 Updating Gripper Jaw Geometry
    20230125 Updating gripper jaw geometry Updated gripper arms design to test picking up bottle  Next steps: need to make mount, I’m thinking o...