Colin Szeto
Attempting to create the ring clamps through scaling the technical drawing 1:1 scale in CAD. Utilized revolve functionality.
Printed out test clamps to verify geometries
20230508 Tuning In the O-Ring Size
Parker handbook 4.3 Face Type Seals “Face type seals are sometimes rectangular. In designing such a seal to receive a standard O-ring, th...
-
Time to test the capability of our prototype torpedo launcher at different distances! The Test Plan We will test the torpedo launcher by sh...
-
After discussion with our mentors, the team defined an updated software architecture. This architecture is reflective of the structure of th... -
Colin Szeto It was only a matter of time when the acrylic interface plates were dropped on the floor and snapped The team pivoted to utilize...
No comments:
Post a Comment