8/28/22 Initial design of the Drone Landing Plate

 

Colin Szeto

The objective is to sandwich the tube clamps between two carbon fiber plates. In this design, the vertical plates constrain 4 tube clamps together to adapt from the motor arm titled up 15 degrees from horizontal to a tube vertical to the floor.
at
Labels: ,

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

20230508 Tuning In the O-Ring Size

  Parker handbook  4.3 Face Type Seals “Face type seals are sometimes rectangular. In designing such a seal to receive a standard O-ring, th...